Deco
Hi, for some reason I can no longer connect to the guest wifi. I have removed security to see if I can log on, and still, the problem persists. This also applies to other devices, so it's not just one
Network ConnectivityGuest Network
By
CAptain_Me
· Latest post 11 hours ago
by Alexandre.
0Helpful
31Views
So I just upgraded from the older XE75 mesh router system to the new BE63. In trying to keep all my old settings i plugged in the new unit add chose to add to my then current setup. After adding to th
Network ConnectivityDeco Ethernet BackhaulGuest Network
By
TheBum0726
· Latest post Monday
by RavenInTexas
6Helpful
380Views
HI there, my network is composed of 9 Deco units, seven of them on V1 with firmware 1.08 (official) and three of them on V2 with firmware 1.0.6, all connected in ethernet bachahul. One of the unit on
Network ConnectivityDeco Ethernet BackhaulGuest NetworkFirmware Update
2Helpful
121Views
I have a new, Deco X50-4G working in router mode using a 4G Sim. I've then got 3 X50 mesh units connected to it either wirelessly or with ethernet backhaul. Standard wifi network works fine across the
Guest NetworkVLAN/IPTV
7Helpful
840Views
I am experiencing an issue with the 2,4 GHz networks provided by my XE70 Pro mesh (3 nodes). The mesh provides 3 networks: main, IoT, and Guest. The IoT and Guest are 2.4 GHz only. The problem became
Network ConnectivityIoT NetworkGuest Network2.4 GHz
2Helpful
135Views
Hello, I recently installed a Deco X10 (3 unit) system at home but am having trouble with my phones connecting to it on the 5GHz SSID. I tried setting the preferrence to 5GHz manually for my S23 Ultra
Connection PreferenceDeco App RelatedNetwork ConnectivityGuest Network
2Helpful
118Views
Hi Team, I'm back again tinkering with my set-up, mainly because I'm bored. So to give you an idea of my current set-up, I live in a small 2-storey townhouse with next door being a single-storey unit.
Access Point ModeNetwork ConnectivityWi-Fi Access ControlGuest Network
By
Joker_1660
· Latest post 2024-10-10 05:49:28
by Sunshine
1Helpful
190Views
I have various devices such as a weather station, boiler and security cameras that have to be connected via the 2.4Ghz network. I can connect to these when the device I am using is connected to the 2.
Network ConnectivityGuest NetworkIoT Networkraspberry pi
0Helpful
132Views
Hello all, i have three Deco XE75 over a switch connected. I have set them to AP mode and see in the Deco App that the Ethernet Backhaul is detected and working. The "normal" WLAN is working very good
Network ConnectivityGuest Network
2Helpful
220Views
Hi there, I'm having issues getting a Deco M5 guest network working correctly. The network topology is very simple, as follows. Deco #1 was set up first, in router mode, then Decos #2 and #3 were adde
Deco Ethernet BackhaulGuest NetworkNetwork Connectivity
By
aatp
· Latest post 2024-08-31 09:46:54
by BlueButter
8Helpful
2382Views