MR100 no 4G signal after last upgrade (1.3.0 0.9.1 v0001.0 Build 210119 Rel.31129n)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MR100 no 4G signal after last upgrade (1.3.0 0.9.1 v0001.0 Build 210119 Rel.31129n)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MR100 no 4G signal after last upgrade (1.3.0 0.9.1 v0001.0 Build 210119 Rel.31129n)
MR100 no 4G signal after last upgrade (1.3.0 0.9.1 v0001.0 Build 210119 Rel.31129n)
2021-05-01 07:54:16
Model: TL-MR100  
Hardware Version: V1
Firmware Version: 1.3.0 0.9.1 v0001.0 Build 210119 Rel.31129n

I use HO-MOBILE provider (Vodafone).

It was working before the upgrade, I saw there was an upgrade available and after that stopped working.

 

Current ISP version: 20082701

 

I also created a new profile but I think the problem is not here.

I don't see "Signal" informatio at all in the status page and this should be present despite the ISP configuration.

 

I suspect there is a problem gathering IMSI from the SIM -> problem the the last firmware -> need firmware fix

 

No possible a firmware downgrade, already tried.

 

2018-10-01 00:27:44 [5] Httpd: Clear log.
2018-10-01 00:27:58 [6] 4G: USER: Not registered, not currently searching!

2018-10-01 00:27:58 [6] 4G: ERROR: Sim IMSI Response Error!

2018-10-01 00:27:58 [6] 4G: WARN: Get SCA fails. CMS ERROR, errno is 500

2018-10-01 00:28:05 [6] 4G: ERROR: Sim IMSI Response Error!

2018-10-01 00:28:06 [6] 4G: WARN: Get SCA fails. CMS ERROR, errno is 500

2018-10-01 00:28:13 [6] 4G: ERROR: Sim IMSI Response Error!

2018-10-01 00:28:13 [6] 4G: WARN: Get SCA fails. CMS ERROR, errno is 500

2018-10-01 00:28:28 [6] 4G: ERROR: Sim IMSI Response Error!

2018-10-01 00:28:28 [6] 4G: WARN: Get SCA fails. CMS ERROR, errno is 500

2018-10-01 00:28:43 [6] 4G: ERROR: Sim IMSI Response Error!

2018-10-01 00:28:43 [6] 4G: WARN: Get SCA fails. CMS ERROR, errno is 500

2018-10-01 00:28:58 [6] 4G: ERROR: Sim IMSI Response Error!

2018-10-01 00:28:58 [6] 4G: WARN: Get SCA fails. CMS ERROR, errno is 500

2018-10-01 00:29:13 [6] 4G: ERROR: Sim IMSI Response Error!

2018-10-01 00:29:13 [6] 4G: WARN: Get SCA fails. CMS ERROR, errno is 500

2018-10-01 00:29:28 [6] 4G: ERROR: Sim IMSI Response Error!

2018-10-01 00:29:28 [6] 4G: WARN: Get SCA fails. CMS ERROR, errno is 500

 

Regards,

Alessandro

  0      
  0      
#1
Options
1 Reply
Re:MR100 no 4G signal after last upgrade (1.3.0 0.9.1 v0001.0 Build 210119 Rel.31129n)
2021-05-10 06:17:19

@marziniconsult 

 

Can we have a screenshot of the Internet Status page when you insert the SIM card into the router correctly? If the SIM card is not detected, please try to reset the MR100 to factory defaults by pressing and holding the reset button until the LEDs flash off then on, take out the SIM card and put it back in, then confirm if it can be detected.

 

Please also try to put the SIM card into a mobile phone to check whether the SIM card still works.

 

You can also refer to this article to check more suggestions: https://community.tp-link.com/en/home/forum/topic/261882.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options