5G/4G Wi-Fi Routers/MiFi
This Article Applies to: M7350 V3/V4/V5/V6.2/V7/V8 Phenomenon Description: M7350 MiFi device is stuck on the TP-Link logo during initialization after restarting Troubleshooting Suggestions: 1. Reset t
OfficialMobile Wi-Fi
7Helpful
4165Views
This Article Applies to: All TP-Link LTE Gateway Routers including Archer MR600, TL-MR6400, etc. Issue Description/Background: Some customers reported that their Jio SIM card was working fine before,
OfficialHighlighted ThreadJio 5G SIM
258Helpful
101410Views
Configuration GuideInstall 5G External Antennas on Archer and Deco 5G Routers
Why the external antennas are necessary? For Archer NX200/NX600 as well as Deco X50-5G/Deco X80-5G, they are all indoor 5G routers. Due to location constraints, it's best to place them near a window f
Highlighted ThreadOfficial
0Helpful
1543Views
Knowledge BaseDeco X50-5G or Archer NX200/Archer NX600
As Mobile service providers continue to roll out the 5G network, upgrading from traditional LTE routers to the latest 5G Technology is becoming increasingly unavoidable. To fully utilize the high-spee
Highlighted ThreadOfficial
5Helpful
9696Views
This Article Applied to Archer NX200(EU) V1 Phenomenon Description: If 5GHz band is disabled and only 2.4GHz network is on, after rebooting Archer NX200, the result is all wireless client devices fail
Official
By
Marvin_S
Marvin_S0Helpful
195Views
We are excited to announce the release of the TP-Link first 5G router--Archer NX200, which takes advantage of your advanced 5G network with download speeds up to 4.67 Gbps. Archer NX200 Hardware Inter
OfficialHighlighted Thread
2Helpful
6285Views
The crux of the question is: Does the Archer NX600 have Carrier Aggregation? And for someone in an area with bad reception, would the NX200 and the NX600 perform the same to improve signal from 4G LTE
Network ConnectivityMobile Wi-FiCarrier AggregationBand Selection
By
peullywo0s
· Latest post 39 minutes ago
by Marvin_S
0Helpful
103Views
Bought a device from ebay and it seemed stuck in a boot loop. I found the recovery tools on here which appeared to be for this device and made sure I could see it in fastboot which I could. Unfortunat
By
tkerby
· Latest post 49 minutes ago
by cloudwalker
0Helpful
138Views
I have installed an Archer NX200 together with a Poynting XPOL-2-5G roof antenna. In the router's admin interface I have enabled external antennas and selected Network Mode 5G/4G/3G. However, accordin
Network ConnectivityInstallation
1Helpful
33Views
Pls help, almost a month since I loaded UNLIDATA 1949 with TNT prepaid. TNT always has that kind of promo I use it for almost a year, then in February my load expired, I couldn't load right away so it
Installation
0Helpful
46Views