5G/4G Wi-Fi Routers/MiFi
Archer NX200 does not display 5G details such a signal strength of N41 even though I am connected to 5G N41. I also found its in band lock and absolutely sure that my area has an N41 signal. However,
Network ConnectivityFirmware UpdateBand Selection
By
Finruhee
0Helpful
38Views
may i know what lte band for redone is best cause i just get 10mbps only better redone setting
Network ConnectivityBand Selection
0Helpful
34Views
The crux of the question is: Does the Archer NX600 have Carrier Aggregation? And for someone in an area with bad reception, would the NX200 and the NX600 perform the same to improve signal from 4G LTE
Network ConnectivityMobile Wi-FiCarrier AggregationBand Selection
By
peullywo0s
· Latest post Friday
by Marvin_S
0Helpful
132Views
Does someone knows which bands are supported for external antennas for this modem Archer NX200? Cannot find in anywhere. Thanks.
Band Selection
10Helpful
2159Views
Hello, I recently purchased an MR505 and very quickly noticed some frequent "disconnections". The router tells me everything is fine, but no Internet traffic goes through. After disabling every servic
Band SelectionCarrier AggregationNetwork Connectivity
1Helpful
84Views
If you have experienced an issue of disconnecting or slowness on the 4G Wi-Fi router’s network due to the auto band selection, Please download and install the following beta firmware on the router to
Highlighted ThreadOfficialBand Selection
158Helpful
159096Views
Country: Italy SIM Operator: Iliad Issue 1: I have been using the Archer NX200 router for two months. During the first month, the router connected correctly to the 5G NSA network, providing good downl
Firmware UpdateBand SelectionNetwork Connectivity
0Helpful
1449Views
I am a user of MR600 V1 in Taiwan. My MR600 V1 router has been unable to continuously enable 4G+ carrier aggregation. It only appears when downloading files and testing speed. Which ISP profile and fi
Firmware UpdateBand SelectionCarrier Aggregation
2Helpful
198Views
Problem: 1. Does not get IP and DNS for IPv4. No internet. 2. Get IP and DNS for IPv6 but get internet connection randomly. 3. Band change option is not found. Band changes randomly. 4. Upgraded the f
Network ConnectivityBand SelectionIPv4 Problem
By
adnan_bafa
· Latest post 2025-02-24 07:31:14
by Marvin_S
0Helpful
96Views
Then theres few problems that risen after using for little time that i hope fixes with future fw updates: 1. Cannot force "only 5g" When you put the modem in onky 5g it just "disconnect" and not even
Band SelectionInstallationTP-Link ID RelatedFirmware UpdatePlease
By
Finnish
· Latest post 2025-02-19 08:08:02
by Luigireport
11Helpful
3196Views