@David-TP 

 

Hi

 

I have tried only 3 access points to upgrade via the web UI as I know all my IP addresses but 2 just say operation successful after clicking on the upgrade after 10 seconds in a little white box and fades away.

 

The access point that was successful had a 2nd pop up that upgraded and then rebooted.

 

I have a couple of access points that drop off, every now and again as well as the off device that doesn't follow me to a new access point also. So these are my reasons to update and see if backhaul being turned off, helps.

 

What should I look for in my logs as I can't see anything that stands out for the upgrade?

 

I haven't even attempted to upgrade my P9 that is my router yet.

 

This is so frustrating and thank you for your reply.

 

Martyn

 

  @David-TP 

 

hi thanks again. I don't think it's updating at all but will try a different web browser as doing it on edge.

 

I do see the access points sometimes go red yes.

 

I will turn off the access points and try later today when I am back in.

 

Will the modem/router update the other 2 that won't update as I know the backhaul telnet fix will get passed on to access points

 

Thanks again

 

Martyn

 

 

 

Just tried via another browser and it did exactly the same thing. It just said operation successful and that was is. I also reset 1 access point to try and see if it was anything on the current set up and that has not made any difference either. Thanks

  @Nytram 

you have to open your Main Deco via Ip in Browser. From there you can select all your P9 Devices to Upgrade. This is the only way it is working. Update via single device isn't working. 

  @Devil1988 

 

Nothing works on the 2 satellite access points but I managed to upgrade my router p9 and then turn off the backhaul and this seems to have worked. I could no see a way to upgrade all my P9s from the main P9 which is my modem too

 

It would be great to get more firmware upgrades on the deco p9 as it does seem to have been left by the wayside for what it does.

 

Thanks again for your help. 👍

@David-TP Hi, could you please PM me the beta software for the P9. I have 3 v2's, and a single v1. What extra features does it contain?

 

Also, is there any optimal configurations I should use with the v1? Should that be the main deco, or a lone satellite with no further connections? My presumption is that it makes no difference, but I just want to be sure.

 

Kind Regards,

John