Range Extenders
The Range Extender products are mainly designed to extend the coverage of your existing wireless network. For some models they even can be used as Access Point devices. In this section you can say hello to other members, ask, answer or discuss technical topics regarding Range Extenders.
Range Extenders
Lead In After connecting the range extender to the Host router, sometimes you might run into the following issues: There are several new clients under the client list. It seems like your own devices a
By
Jenny_M
Jenny_M1Helpful
1571Views
Hi, I leave in a 4 stories house. My router is Archer AX6000 and is OneMesh enabled. I have a RE330 which is OneMesh enabled at level 3 and it work well. For some reason, my level 4 get very weak wifi
0Helpful
22Views
As in the title. Signal light is on in Extender mode but is off in Access point wired mode. Unplugged the wire, rebooted into Extender mode, then switched to Access point mode and plugged in the wire
Access Point Mode
0Helpful
32Views
Hello, I have an RE200 V5 that I use as a wireless adapter (ethernet cable to desktop pc) Which I now have problems with. Sometimes when you connect it to power, or when it runs for about 30 minutes,
0Helpful
45Views
Hi I set up my RE650 as an access point. It got connected but the wifi is not protected. I tried to modify the configuration to encrypred but it's not accepting the change and goes back alone to no pa
By
Mohammedkh
· Latest post Yesterday
by Joseph-TP
0Helpful
17Views
Hi. We are renting an apartment in a comercial building and we are sharing a fiber connection with the house. The router is about 30 meters from the apartment and its not an option to connect our deco
Network Connectivity
By
OldBuilder
· Latest post Yesterday
by Joseph-TP
0Helpful
35Views
Official ReleaseEasyMesh Range Extenders Start Supporting Building a EasyMesh Network via Ethernet Backhaul
This Article Applied to: RE315_V1 RE315_V1_1.0.30 Build 230919 RE900XD_V1 RE900XD_V1_Build_20240411 RE655BE_V1 Supported on the factory firmware. RE800BE_V1 Planned What is EasyMesh with Ethernet Back
Firmware UpdateEasyMeshEasyMesh Ethernet Backhaul
132Helpful
21707Views
I reached out to technical support earlier, but they could only advise that EasyMesh for the RE815XE is planned and I wondered if anyone knows if there is an ETA for when this would be. I recently pur
EasyMeshWi-Fi 6E
By
maverick1103
· Latest post Yesterday
by maverick1103
1Helpful
140Views
I was wondering if it is possible now or in the near future to manually block individual IP Addresses that's connected before without actively being on my AC750 Wireless Extender? If not, when would b
Access ControlNetwork ConnectivityFirmware Update
By
DaisyChainWiFi
· Latest post Yesterday
by harshitgoyal742
3Helpful
143Views
Recently I bought re705 extender and now part of to one mesh but can't see big benefit. What should I do ? My Vdsl modem archer vr400 and i wonder making re705 a hot spot too see my devices doing bett
OneMeshEasyMesh
0Helpful
49Views