Dear All, I have a question on building up mesh network with model EAP225 & 610, are they 2 different model able to build up mesh ? if they do, do i need to install Omada controller in order to build

@Fae Overview and Statistics should be visible simultaneously. See attached GIF. In the actual interface, if you expand one the other retracts and you have to switch between the two, despite there bei

Anyone or @Fae @Hank21 I wonder where to define threshold on EAP Force-Disassociation option. The help text says this. Force-Disassociation: When disabled, the AP only issues an 802.11v roaming sugges

Here is a diagram showing my current setup and planned setup, with the "?" Indicating the device I need help deciding on. The POE devices are 48 volt. I would prefer the switch to be Omada compatible

Not sure but these numbers seem quite high. I recall reading that there was an issue with the reporting but I think it was addressed in a firmware update. What can I do to investigate this?

I am a bit confused on the LAN setting in the OC200 Hardware Controller. I plugged the OC200 into one of the modem / routers ports. It adopted without issue. All APs are adopted and connected. Interne