Hi, I have a 3-device mesh set up using X-50 units. One is connected by cable to my Internet Provider's router, and the others are located on another floor below. It used to work fine but since I move

Is it okay to buy the Deco X60 v2 single pack right now to use as a main router with these?

Hello everyone, I have a question regarding my Deco M4 network setup. I currently have three Deco M4 units, all connected via Gigabit switch using Ethernet cables. During the initial configuration, ev

When I test speed with PC connected direct to router I get speeds of 900-950 Mbs. With my main Deco M5 hard wired to the router with the supplied cable and the PC connected to the second port on the M

I have an archer axe5400 tri band right now , it's only a room away but the connection quality is bad (packet loss) my speed is fine about 500 mbps out of 1000 but my packet loss is severe so I was wo

Hi, My setup is: Internet via fiber => Main Deco M5 (in router mode, via one of the LAN ports) => Zyxel switch (via the Deco's second LAN port) => Satellite Deco M5 (connected via Deco's LAN port) I h