@StFual So to be certain I should reset the router, configure LACP and then switch it to AP mode ?

@StFual Tested the 15M SFP+ 10G Fibre backhaul. It worked but it only ever ran at 1Gbs . Tried combinations of reboot and replug but never saw faster than 1Gbs. Also the negotiation was slow compared...

Does the BE800 formally support LACP in Access Point mode? I note there are options in the BE800 WR to configure pairs of LACP ports but not in the BE800 AP. However it seems to work but not...

@Kevin_Z Apologies for the late reply. As all the software and firmware in my system including the BE800, QNAP and Windows 11 has updated in the last two weeks i've been retesting . Rather than...

@Kevin_Z My ISP AIS Thailand wont support a BE800 with a PON at the current time. My contract has 10 months to run so i'll look at the alternative ISPs in Thailand and think about swapping then. It...

Is there an update on this? I am discussing with AIS my ISP on using a GPON directly into the BE800 instead of running through a Huawei router that they use as their home fiber termination. They are...