@Clive_A I did attempt LAG but I believe the router does not support it. I can double check. If I remove vlan 1 from ports 17, 19, 21, and 23, leaving just the intended vlan, that should allow them...

I was hoping I could have the physical connections like in the table below and apply some network segregation rules at the Omada Router and apply the main firewall traffic rules at the PfSense. When...

@MR.S Initially I was going to direct specific LANs through the ports so I could regulate them. Each time I attempt to segregate a LAN to a specific port>WAN. It doesn't seem to work. Sort out the...

Arris G54 - Bridge mode, firewall turned off. IPv4/IPv6 DNS Relay is enabled DHCP Server is not enabled Omada Hardware Controller OC200 2.0 EAP783(US) v1.0 Firmware 2.16.3 Build 20240620 Rel.81038...