@Hank21 , the issue only seems to affect KASA devices, I have all of the APs on different channels. What I do see on the Wi-Fi Traffic Distribution graph, the APs show in red a lot of the time and...

So I have 2 EAP245 access points and IPs are being assigned via Pfsense. The full setup is running Omada 5.9.31 software which controls 6 switches and 3 APs. For some reason if I restart the access...

@PatrickMcC As an additional update, I got 2 TP-Link 10gbe transceivers and I still have the same issue. I plugged the two TP-Link transceivers into the switch with fiber running to both PC and...

btw, the NICs are Mellanox MCX311A-XCAT CX311A ConnectX-3 EN in both machines.

The NAS is an Unraid server, it does not have LAG/LACP enabled. All connections are showing 10g Duplex connections. I have done iPerf3, the results are below. Unfortunately I am getting no where...

Hi all, So I got this switch a week ago and I have been struggling with getting good speeds from it. The switch shows I am connected at 10gbe and the connected NICs also show 10gbe, but I am only...