@Somnus In fact, I used a USB to RS232 cable connected to the RS232 to RJ45 cable and it worked, it accepted the commands easily. Too bad there isn't a physical "reset" button on switch.

I have a TL-SG3210 that was managed by an OC200 Omada controller. During this management, the OC200 defined an unknown random password for the switch, in order to adopt the device. However, it was...

I've tried performing these steps, but the devices are always thrown on an unrelated subnet. Ex.: 169.240.X.X Since everything is configured to be 192.168.VLAN-ID.1/24

I have two EAP235-Wall which are controlled via Omada OC200. It happens that if a user connects a network cable to the ETH1 or ETH2 port, the user has normal access to the network and the internet....

I have an Omada network set up in a small office, basically using WiFi for all users. But it will grow in number of users, devices and rules for access between networks. I have the following TP-Link...

@d0ugmac1 My problem is that I am using TP-Link TL-SG1008P switch, which is not compatible with Omada and also not manageable. Will I have to put a JetStream switch (eg TL-SG3210) on the network to...