Good Evening Today I came to the site where I have the problem with the SG2008 switch with the vlans. I checked the DST on both the site and the controller and both were disabled. I enabled them and...

Good morning I haven't done anything because I had another serious problem and couldn't go to the site to check it out. This weekend I will go and check it and let you know. Thanks for the question.

@MYN Thank you for your answer. I will check the DST settings in the omada software controller. DST has never been activated and from a quick look I saw in the configuration it is disabled. I...

I use SG2008 under omada software controller to share some vlans. After the last upgrade it stopped pinging the different vlans, I can only ping the gateways for each vlan but not the terminals .I...

Hello again. I want to inform you that the problem I had with the prints has been solved. As user alex789 had mentioned, I reinstalled the printers with the new ip address of the vlan and they are...

Hello again When the printers are on the same vlan they work fine. The gateway is the right one. As you will see in the diagram, there is a problem between vlan10 and vlan20. When I try to print...