@knyttl There are no settings to stop two units (Main and Satellite) connected to each other with Ethernet cable from using that Ethernet cable. Satellite Deco will immediately start using Ethernet...

@michaelmit Also, check if you perhaps accidentally blacklisted your computer in Deco app. See How to block a device or remove a device from the Deny List If Deny List (Block List) is not empty,...

@knyttl There are two possibilities: 1. From the photo, I can tell that switch you are using is from D-Link. This brand of switch is known to have issues with Deco Ethernet backhaul. If you have...

@yxedeco My primary Deco is connected through the switch. It can be done. In Access Point mode, you do not need to make configuration changes on Rogers Xfinity Gateway. The only recommended change is...

@yxedeco Great. The best placement for Deco units is where they can be connected by Ethernet cable to that switch. You will need to run Deco mesh in Access Point mode, this is configuration setting...

@yxedeco The requirement for Main Deco is to be connected with Ethernet cable to ISP modem/router. This could be long or short Ethernet cable, as long as it works. You do not need to place Main Deco...