Can't create mesh network using NX200 and RE305
Hi,
I've spent a couple of hours now trying to add my RE305 as a mesh device to my newly installed NX200. I've read previous posts here but was not able to solve the issue. Everything is updated with latest firmware, restored and updated again etc. Help!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Gribbyn,
If you have smart connect" activated in the Wireless Settings menu of the NX200 switch it off.
Then try WPS buttons to create easymesh network between NX200 and RE305.
It is recommended that you can factory reset the RE305 before you set up easymesh network:
Keep power on, Use a pin to press the reset button(hole) for 1 second to reset the extender
- Copy Link
- Report Inappropriate Content
Hi @Gribbyn,
If you have smart connect" activated in the Wireless Settings menu of the NX200 switch it off.
Then try WPS buttons to create easymesh network between NX200 and RE305.
It is recommended that you can factory reset the RE305 before you set up easymesh network:
Keep power on, Use a pin to press the reset button(hole) for 1 second to reset the extender
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 142
Replies: 1
Voters 0
No one has voted for it yet.