Hi. Good afternoon here at Philippines. Just want your input in my issue. I have 1 Deco M5 and use it as my Main Router for me to monitor all devices connected to my network. I used a disconnected ISP modem/router as AP connect it via LAN port of TPLink gigabit switch 4 ports then gigabit switch to Deco M5. The first time i try this kind of network works very well. I have a 800mbps plan from my ISP and I've always get that speed when i'm trying to perform a speedtest or download something. But then i try to download a movie from Torrent and my download speed is now getting half of my 800mbps plan. I tried to speedtest directly to ISP modem/router and i'm getting a full 800mbps dl and ul but when i connect the deco from the ISP modem/router, the download getting half of the speed again. The upload didn't seem have an issue since its getting a full 800 mbps (sometimes 900) but the download isn't. This issue started only when i tried to download from a Torrent service (qbittorrent). Is it possible that the Deco M5 have some internal download limiting issue when there's a heavy downloading? I can't reset that Deco since i already configure all my self-hosted service's static IP address and blocked some didn't recognize devices. I check the QOS and set the limit to 1023 same download and upload but issue still persist. also tried to change the qos mode from standard to game, stream, etc but same issue. I also tried to change the ethernet cable, change ethernet port in ISP modem/router and in Deco M5 but issue still there. Just an additional, issue persist same on access point and router mode. Hoping you can help me with my issue. Thank you.