Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Hello,

I purchased a TL-WPA4220KIT yesterday and attempted to set it up yesterday. At first I was attempting to clone my WiFi using the clone button on the powerline and the WPS button on my router. After doing this the powerline adapter was still broadcasting its own network. I assumed this was showing that it never cloned the network, as if it did, it would only broadcast my own network?

I then logged into my router as admin and manually attached the powerline adapter via the WPS settings. The powerline adapter then stopped broadcasting its own network but I wasn't sure how to check exactly what network the adapter is broadcasting?

The reason I purchased it was to amplify my signal in parts of my house that only had a weak signal from my router. After doing the above and think I have connected the adapter to my wifi successfully, it doesn't seem to be amplifying my signal. Does it look like I have done anything wrong?

Cheers

(I had a look through the forum but could not find anything that replicated my issue)