NX200 and RE605X mesh network
I have recently bought NX200 and expect to build a mesh network with my RE605X v1.0 1.0.4. But I am not able to make a single network, it always creates EXT network. Is there a way to solve this?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Check your RE605X version, Only selected version support/compatible easymesh. Older could be only onemesh.
- Copy Link
- Report Inappropriate Content
@myag but.... easymesh is not compatible with onemesh? i think I saw it still states the compatibility....
- Copy Link
- Report Inappropriate Content
I remember tp-link listing product and version numbers, I can see amazon listing packings with image of onemesh or easymesh seperately for AX1500 series.
I also see you have 1.3.0 firmware but this is not available anywhere except thailand as country specific.
- Copy Link
- Report Inappropriate Content
@myag Well I bought it in Greece... just too disappointed I need to buy an additional device (on top of the nx200) to cover my place as hate that network switching...
- Copy Link
- Report Inappropriate Content
Ok. Seems all new device coming with new firmware.
I too bought week ago and suprised it is still v1 and old firmware. I dont see much difference in 8 antenna NX200 vs Samsung M23 (tethering) in 5G reception.
- Copy Link
- Report Inappropriate Content
@Marvin_S got it... thanks(( little bit disappointed I need to buy another stuff... any recommendation for an additional device to work with nx200? need to extend network in 3 level house...
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, if your house is 3 floors, it is more suggested to consider the Deco mesh network.
You may refer to this guide to know more: Can Deco Mesh, OneMesh, EasyMesh and Omada Mesh products work together?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 164
Replies: 8
Voters 0
No one has voted for it yet.