Hi,

In my house i have the following setup:

Fiber connection to the house(1000mbit). From fibre converter, ethernet cable to port 1 of primary Deco node. Primary node is situated on the ground floor.

This has been working so far.Both other nodes has been connected via wifi.

As i started to stream 4K movies (TV on top floor) - i was not happy with the performance from the node on the top floor. So i bought an ethernet cable (Cat6) and put it from port 2 of the primary node to the 1st port on the node upstairs. However, the node upstairs does not switch from wireless to ethernet connection.

I pluged my computer directly to the ethernet cable, and the signal is fine. Any thoughts?