Archer MR 600 Auto Reset Issue / Please HELP !!
Good afternoon. I have been reading the previous thread about this isue. Nobody came with a solution. Thread has been closed.
I have a MR600 with the same problem. Its in a remote location and powered by solar panels and battery deep cycle. To avoid draining the battery I installed a timer. In the night the MR600 is switched off. For the second time I had to fly to France, again the complete programming was gone, back to factory setting. Why is this happening ?? Please help !!!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Amtsop I am going to reply to my own post. I have been spending some hours reading on this forum about the problems a lot of people have with the Auto Reset Issue of the MR-600. Nobody came with a solution. I am sure the problem happens when it is switching off and on after several hours. Could it have a memory backup battery like a CR 2032, what looses its voltage ? I had similar problems with other equipment loosen its programming due to memory back up battery low on voltage. Did anybody check this ??
- Copy Link
- Report Inappropriate Content
Hi,
How often will the MR600 auto reset?
Have you tested plugging it into a stable wall outlet and testing if the auto reset occurs?
- Copy Link
- Report Inappropriate Content
@Amtsop Thanks for your reply, the full reset happens frequently after switching off and on. The MR-600 is at a remote location. Powered bij solar panels and a battery for storage. A timer controls the on and off times of the Mifi MR-600 and other equipment. Every day it is on from 1 PM till 6 PM. It works well fo a few days, maximal a week and then suddenly the complete programming is gone. I have to fly again from the Netherlands to France to reprogram the RM-600. I contacted by phone customer support, but they cannot help me with this issue. I have been reading on this forum, I am not the only person with this problem. But nobody came with a solution.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 137
Replies: 3
Voters 0
No one has voted for it yet.