Home Network Community > 5G/4G Wi-Fi Routers/MiFi > Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
< 5G/4G Wi-Fi Routers/MiFi

Troubleshooting Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo

12

Troubleshooting Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo

TroubleshootingBoot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-03-15 10:19:02 - last edited 2024-04-02 09:25:25
Tags: #Official #Mobile Wi-Fi
Model: M7350  
Hardware Version:
Firmware Version:

This Article Applies to:

M7350 V3/V4/V5/V6.2/V7/V8

 

Phenomenon Description:

M7350 MiFi device is stuck on the TP-Link logo during initialization after restarting

 

Troubleshooting Suggestions:

1. Reset the MiFi device: Hold the reset hole for approximately 10 seconds.
2. Remove the battery, reinsert it, and attempt to turn on the device again.
3. Perform a firmware recovery: Download the relevant firmware recovery tool from the links below:
M7350 V3_RecoverFirmware
M7350 V4_RecoverFirmware
M7350 V5_RecoverFirmware
M7350 V6.2_RecoverFirmware
M7350 V7_RecoverFirmware
M7350 V8_RecoverFirmware


Note: Please refer to the included "readme" file in the download links for instructions on performing the firmware recovery process.

 

However, if the above suggestions do not resolve the issue, it is possible that the MiFi device is defective. In such cases, we recommend contacting the retailer from whom you purchased the device or reaching out to the local support team to inquire about warranty options.

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0      
 
  0      
 
#1
Options
13 Reply
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-03-25 12:06:17 - last edited 2024-03-25 12:07:12

  @Soleilsalut, j'ai un modem TP link m7350 v3 que grâce à vous j'ai pu récupérer mais quand j'essaye de mettre à jour au fichier update zip ça ne passe pas. Que faut-il faire. 

Le modem mâche normalement saufil n'y a pas de connexion même avec les APN de l'opérateur.

N.B je suis au Maroc.

Merci 

  0  
  0  
#5
Options
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-03-26 03:09:28

  @Elma79 

 

What is the current firmware version of your M7350 V3? 

You mentioned there is no internet, please share with us screenshots of Advanced->Status page, Advanced->Dial-up->Dial-up Settings page

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#6
Options
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-03-30 11:22:44 - last edited 2024-03-30 11:38:49

  @Soleil  merci d'avance pour votre soutien.

Frimware version 1.0.9 Bouild 151021 Rel1017n

model M7350(UN)

  0  
  0  
#7
Options
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-03-30 11:24:22 - last edited 2024-03-30 11:40:45

voilà les captures d'écran

 

File:
m7350.rarDownload
  0  
  0  
#8
Options
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-04-01 03:08:17

  @Elma79 

 

Hi, based on the screenshots, there is no any 3G or 4G signal received by the M7350(check the signal on the upper right side of the web interface), please try to download firmware from this website, try M7350(EU)_V3_190531 and M7350(EU)_V3_160330:

Firmware Download for M7350 V3

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#9
Options
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-06-10 07:12:50

@Sunshine 

Could you kindly provide the current firmware version of your M7350 V3?

Since you've mentioned the absence of internet connectivity, it would be immensely helpful if you could share screenshots of the Advanced->Status page and Advanced->Dial-up->Dial-up Settings page.

Your cooperation will greatly assist in diagnosing and resolving the issue.

If you find any of the responses helpful, don't forget to click "Helpful". If an answer successfully resolves your problem, marking it as "Recommended Solution" will enable others to benefit from the solution as well.

 

Warm regards,

John smith

computer networking assignment helper


 

  0  
  0  
#11
Options
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-06-10 18:59:20

  @smithjohns 

Hi, thanks for the message here are some screenshots I hope they will be helpful in resolving the issue.

I remind you that my problem is the following: after recovering my device I configure APN as required but the device remains disconnected.

  0  
  0  
#12
Options
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-06-12 18:09:13

  @smithjohns Helpful

  0  
  0  
#13
Options
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-07-12 14:23:09

  @Sunshine @Marvin_S I follow this article but this error occurs

  6  
  6  
#14
Options
Re:Boot Loop or Boot Failure on M7350 V3/V4/V5/V6.2/V7/V8: Stuck on TP-Link Logo
2024-08-27 23:57:44

  @Sunshine My M7350 v6.2 has suddenly started to spin in an 'initalizing' loop and won't connect. If I take the SIM card out it powers on OK. Its not the SIM as it does the same with a different SIM. 

I've tried to install the firmware update but it gives the error shown.

 

Any ideas how to fix please?

 

  0  
  0  
#15
Options
12

Information

Helpful: 0

Views: 2905

Replies: 13

Tags

Official Mobile Wi-Fi
Related Articles
m7350 v8 stuck on boot loop
1088 0
Boot Loop
554 0
 M7350 Boot Loop
1247 0
 M7350 v3 - Can't boot
1010 0
M7350 v6.2 - Firmware recovery too
621 0
 M7350 V1 Boot Logo
504 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.