@David-TP 

Hi David-TP

The ADC SVR-122 NVR is connected via ethernet to the switch - I cannot connect it to the main Deco as there are only two ports on the X60 (one used for WAN/Internet and the other to the switch).

The cameras and the NVR are connected as you have in your diagram.

The Operation Mode is Wireless Router.

Rgds

P.

  @David-TP 

Hi David-TP

I have previously, individually and together in all combinations, turned off Beamforming, Fast Roaming, and Mesh Technology - I have also re opted the Deco's individually and in particular sequences, none of this has helped.

I previously had older ADC 720P WiFi cameras on the M5s and these worked as fine/as expected. I upgraded to X60's in the same physical locations as the M5s and ADC 1080P WiFi cameras in the same physical locations as the older cameras.

The intermittent behaviour starts from around 5 in the morning until around 10 at night. There is no additional network load until 10 in the morning - multiple users, streaming, etc doesn't appear until 5 in the evening.

I have also noticed that the cameras that are most intermittent are the ones connected to the satellites, the Main unit operate best most often. I have checked this with both ethernet backhaul and WiFi backhaul - it is like the satellites are not communicating as well as they should with the main unit.

The loss of the ability to select preferred node and to select between 2.4Ghz and 5Ghz is a real annoyance - when will there be an update to provide this functionality to the X60's? It make no sense that it is available for an old product and not a newer one.

Thanks

P.