TL-PA8030P 3xGigabit ports, only transfers at ~150mbs down/up

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-PA8030P 3xGigabit ports, only transfers at ~150mbs down/up

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-PA8030P 3xGigabit ports, only transfers at ~150mbs down/up
TL-PA8030P 3xGigabit ports, only transfers at ~150mbs down/up
2023-04-03 21:57:09
Model: TL-PA8030P KIT  
Hardware Version:
Firmware Version: 2.7.0.44-02_803113_200117_901

All ports feedback (router and switchs), OS diagnostics and TPLink tpPLC sw, reports the connection as 1000mbs/1gb, but when I do a speedtest on one desktop connected via TPLink, I can only download/upload at ~150 ish mbs, but if I connect the desktop/laptop directly to the router or via wifi, it downloads at ~550 ish mbs.

Both devices are plugged directly to the wall plug, and both rooms are on the same electrical circuit.

What could be the problem.

PS: The TPLink tpPLC sw, reports the connection between both devices between 250/300 mbs.

  0      
  0      
#1
Options
1 Reply
Re:TL-PA8030P 3xGigabit ports, only transfers at ~150mbs down/up
2023-04-04 07:57:35

  @ValleyInDk 

 

Hi, do you mean the powerline rate between the two powerline units are only 250mbps/300mbps? If so, the issue is caused by low powerline rate, which is usually affected by powerline environment, please refer to the instruction below to see if it can be better:

What can I do if my powerline rate is very low?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options