Archer MR600 v2 Error during upgrade firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer MR600 v2 Error during upgrade firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR600 v2 Error during upgrade firmware
Archer MR600 v2 Error during upgrade firmware
2023-03-27 16:24:46 - last edited 2023-03-27 16:25:47
Model: Archer MR600  
Hardware Version: V2
Firmware Version: 1.0.0 0.9.1 v0001.0 Build 210629 Rel.59196n

Hi,

I'm trying to upgrade firmware in my router. When uploading Archer MR600(EU)_V2_210208 throu control panel at about ten percent I get 4503 error code, newer firmware gives 71211 error code. Router I have from secound hand.

Can some one suggest solution?

  0      
  0      
#1
Options
2 Reply
Re:Archer MR600 v2 Error during upgrade firmware
2023-03-28 07:03:05

  @MatthewDruid 

 

Hi, upon checking, your current firmware is a customized firmware for PLPLAY(ISP Play in Poland), so it cannot update to other common EU version firmware.

 

By the way, the firmware you're trying to install (Archer MR600(EU)_V2_210208) is older than your current firmware, there is no need to install it.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  1  
  1  
#2
Options
Re:Archer MR600 v2 Error during upgrade firmware
2023-03-28 07:22:02

  @Sunshine 

Thank you for reply. I expected that it can not be upgraded but I hopped that there is some solution to change/upgrade firmware manually

  0  
  0  
#3
Options