Deco M5 Change from AP Mode to Router Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M5 Change from AP Mode to Router Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Big-Bert

2022-05-18 20:02:02

Posts: 2

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2022-01-09

Deco M5 Change from AP Mode to Router Mode

2022-05-18 20:02:02

Model: Deco M5

Hardware Version: V3

Firmware Version: 1.5.7 Build 20210819 Rel. 43499

I currently have a 3 x Deco M5 running without issue in AP Mode. The main Deco is connected to an Archer C3200 router with wireless switched off and this in turn is connected to a Virginmedia Hub 3 running in modem mode. I was looking to remove the Archer C3200 and connect the main Deco 5 directly into the Virginmedia Hub 3 but if I change the Deco M5 from AP Mode to Router Mode will I loose the existing settings?

2 Reply

David-TP

2022-05-19 06:34:06

Posts: 12772

Helpful: 1790

Solutions: 1294

Stories: 9

Registered: 2020-04-14

Re:Deco M5 Change from AP Mode to Router Mode

2022-05-19 06:34:06

@Big-Bert

Welcome to the community.

What settings you might refer to, the wireless SSID and password, or something else?

Basic wireless settings, like wireless name and password, would still be the same. And most of the clients will connect automatically after switching the mode.

Best regards.

--------------------------

Deco X50-PoE is ready for your advice. Please help us complete the following survey.

Deco X50-POE Survey

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.