Lock down the modem if adds child deco

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

Lock down the modem if adds child deco

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Lock down the modem if adds child deco
Lock down the modem if adds child deco
2021-10-14 02:47:08
Model: Deco X20  
Hardware Version:
Firmware Version:

Hi, 

 

The diagram below is the distribution of my home network.

Red line means the connection is using cable (RJ45).

Brown lin means if any one of these connections is setup, the modem and all decos are hold. (Deco shows 'red light' on and both IPTVs are gone)

That is, the DHCP of the modem seems 'failed' and others cannot get IP assignment.

I need to disconnect 1st deco and 2nd deco, reset modem and main deco, then all are working well (excepts two child decos)

I don't like to let decos act like AP. I would like to have those features that deco provide.

Is there any solution can make this distribution working well ?

P.S.: Now the solution I can have is the two child decos are working in 'wireless'. The drawback is the location of these child deco are limited. This is not useful for me.

 

Your advice is welcome

 

  0      
  0      
#1
Options
11 Reply
Re:Lock down the modem if adds child deco
2021-10-14 07:37:17

@XJRHD 

Hi, if Deco works on the wireless router mode, only the main Deco could connect via Ethernet cable to the ISP modem, which might be why Deco turned red.

You could try to move the main Deco between modem and 1st switch, like:

  0  
  0  
#2
Options
Re:Lock down the modem if adds child deco
2021-10-14 09:52:36

@TP-Link 

 

Thank for your quickly reply.

I cannot move main deco between 1st switch and the modem as they are located on different floor.

And the modem I had which has the feature of wifi router.

My house has 4 floors. And I only have 3 decos.

My plan is first floor uses the modem within wifi router, each deco locates on 2nd, 3th and 4th floor.
1st IPTV locates on 1st floor and 2nd IPTV locates on 4th floor.

Is this achievable ?

 

  0  
  0  
#3
Options
Re:Lock down the modem if adds child deco
2021-10-20 11:15:31

@XJRHD 

Hi, it is ok.

But I suggest that you put the main Deco at the front and connect to the 1st switch:

  0  
  0  
#4
Options
Re:Lock down the modem if adds child deco
2021-10-20 11:20:42

@TP-Link 

Your suggestion was the first usage I did.

Then it failed.

As the subject described here, hangs up once a child note added.

  0  
  0  
#5
Options
Re:Lock down the modem if adds child deco
2021-10-20 12:18:56

@XJRHD 

Hi, I see from the first pic, I thought the main Deco was at the back and on the router mode, so actually, it is the first unit connected to the modem via a switch and on access point mode, right?

 

And Were you able to reprocess the same issue all the time?

May I know the model number of your ISP modem and the two switches

Thank you very much.

  0  
  0  
#6
Options
Re:Lock down the modem if adds child deco
2021-10-20 12:57:03
I will reply this weekend. Thanks for uour quickly and kindly reply.
  0  
  0  
#7
Options
Re:Lock down the modem if adds child deco
2021-10-21 03:35:00

@TP-Link 

 

I can answer partial of those questions you asked :

 

1. Yes, I can repeat the hangs up issue after adding a child node everytime.

2. Switch : TPLink  TL-SG108

 

3. ISP modem : I will provide this this Sat.

  2  
  2  
#8
Options
Re:Lock down the modem if adds child deco
2021-10-21 07:35:55

@XJRHD 

Hi, thank you very much for the update.

I would like to follow up on your case by email and please also update the model number of the ISP via email as well.

  0  
  0  
#9
Options
Re:Lock down the modem if adds child deco
2021-10-24 01:38:19

@TP-Link 

 

Here you are.

The model name is described on first line.

Let me know if you have any question.

  2  
  2  
#10
Options
Re:Lock down the modem if adds child deco
2021-10-25 02:47:49

Hi,

 

I illustrated more as shown below:

P.S.: If there is no 2nd IPTV, the connection is working fine.

 

  2  
  2  
#11
Options