TV box cannot connect via wire.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello.
I cannot connect the TV box (TOX1) to the router using a wire.
Wi-Fi works fine, but the box and the router cannot see each other over the wire.
My Internet Connection type: Static IP.
I tried:
- change DNS addresses in the router settings (8.8.8.8).
- change the duplex / 100/1000 MBit parameters.
- change the IP address of the local network.
- reserved the local address for the tv box (wrote the address in the box settings, but the Internet did not work).
- turn on and off IGMP.
- use other wires.
What else do you recommend to try?
ps. but 4G router TianJie CPE903, connects and works perfectly, so the problem is not in the TV Box.
ps2. but computer is connected through a wire without a problem.
When TV box is connected with ethernet cable, can you ping the device from computer via its IP address ?
Or vice versa, ping the computer or router from the TV Box to check if its LAN connectivity is OK.
You can check also the TV BOX connectivity here:
Have you tried to change the DNS here:
Hello @Kevin_Z .
If you need it, you can remotely connect to my router.
Yes, I reserved the IP address 192.168.0.12, because it has a Samba server.
Now I have removed all reserved addresses. I'll check it out. But the first connection didn't work better, the router and box didn't connect quickly.
Thanks you.
ps. Nothing has changed, Box has lost its IP address again.
Now I do not use Samba server and Box has default parameters (get ip from DHCP server).