@Sunshine 

Thannk for your kind replay !!

Some others infos:

 

1) in my configuration i use Static IP : example 192.168.0.4 (see down)

 

 

2) when the managemnt page isn't reachable the ping to router is correct:

 

 

3) with the browser if i try with 192.168.0.254 ( same with http://tplinkmodem.net/ ) i see a loop of the little bal left to right (see down)

 

 

4) When the mgt page isn't reachable  with 192.168.0.254 also with xxxxx.dyndns.info:8080; when run all fine BOTH (local &remote) are ok !!

5) Remember :EXCEP the router management page NOT reachable the rest run all fine like: internet connection, remote control (Teamview, VNC) ecc.

 

Again thanks for support !

Luciano

@Sunshine 

Thanks!

Last news!

Yesterday 14th at:

15.00 web mgt page NOT reachable 

15.05 router power off ->on

15.10 web page mgt NOT reachable

15.20 change the old router with a NEW router (SAME model ! ) loaded with the configuration previous saved from the old router

RUN ALL VERY WELL inclusive the access to web mgt page ( both from 192.168.0.254 or from xxxx.dyndns.info:8080) (i think  neutral the Virtual Ethernet adapter!)

SINCE Yesterday the web page mgt is reachable.......i hope continues !!!!!

 

About your question:

Have you had any issue when the wireless devices are connected to the Archer MR200?

n. 2 cameras are conntected at Router wireless without problems !

 

(*) the old router was purchased in January

 

update 17th:

The web page mgt still reachable

 

 

 

Best regards

Luciano

:

 

 

 

 

 

 

 

 

@Sunshine

Hello,

After c.a.10th days run all very well !

I check every day  the web mgt page (also remotly) and it's always reachable!

 

Now:

According this issue, in the recently past i reset the first router to factory and i reload on it the configuration used currently from this spare router.

 

Question:

Some other suggestion ?

The first router is only 8 months old.....

Thanks very much !

Luciano