New router, can't use internet after WAN setup
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I've recently bought a router, its the MR200. This router has two functions, one using SIM, the other using WAN Connection
I wanted to use WAN Connection because I have a house modem.
I've gotten the username and password from my ISP to setup using PPPoE, but internet still doesn't work.
please help
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Login to the web UI of the Archer MR200 first.
And then go to advanced-operation mode to change it to wireless router mode. And then you can use the username and password to configure it.
May it help.
- Copy Link
- Report Inappropriate Content
hi, I've done what you've told me, but it still doesn't work. It ends up with it showing "Sorry internet not connected, please reconfigure your parameters"
the username and password is correct, for I've called my ISP for it
- Copy Link
- Report Inappropriate Content
Thanks for your reply.
Please show us a screenshot of the advanced-status page.
Meanwhile, what is the current operationg mode of the MR200? What is the led status of it?
With the sim card inserted into the smart phone, does it work well?
Have you ever tried to create the connection profiler manually under advanced-internet-dial up page?
Good day.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
Since the original post is quite a long ago, could you please start a new thread about your current issue?
At the same time, please refer to this link, and then you could update on the new thread about which one is quite like your case:
[Troubleshooting]No internet service on LTE Gateway Router
Moreover, you could also add your current model number as well as hardware and firmware version.
Thank you very much.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1175
Replies: 5
Voters 0
No one has voted for it yet.