Wireless Security not applied on TL-WR741ND v2.4
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wireless Security not applied on TL-WR741ND v2.4
Model :
Hardware Version :
Firmware Version :
ISP :
Hello all
I've got TP-LINK TL-WR741ND v2.4 (firmware upgrade-a is not available) and I'd like to enable WPA-PSK2.
Tutorial: http://www.tp-link.com.au/faq-256.html http://www.tp-link.com.au/faq-256.html
Before I start I perform factory reset of the device. After executing steps listed in the FAQ and performing reboot of the device, the wireless network still remains Open - as if I would have selected "Disable Wireless Security".
I recheck configuration for Wireless Security in GUI and the configuration for WPA-PSK2 is there - it persists across reboot. If I try to change the SSID this gets applied. I've tried several password lengths and different complexities... but none of that helped...
Am I missing something really obvious?
PS.:
Firmware Version: 3.12.4 Build 100910 Rel.57694n
Hardware Version: WR741N v1/v2 00000000
Hardware Version :
Firmware Version :
ISP :
Hello all
I've got TP-LINK TL-WR741ND v2.4 (firmware upgrade-a is not available) and I'd like to enable WPA-PSK2.
Tutorial: http://www.tp-link.com.au/faq-256.html http://www.tp-link.com.au/faq-256.html
Before I start I perform factory reset of the device. After executing steps listed in the FAQ and performing reboot of the device, the wireless network still remains Open - as if I would have selected "Disable Wireless Security".
I recheck configuration for Wireless Security in GUI and the configuration for WPA-PSK2 is there - it persists across reboot. If I try to change the SSID this gets applied. I've tried several password lengths and different complexities... but none of that helped...
Am I missing something really obvious?
PS.:
Firmware Version: 3.12.4 Build 100910 Rel.57694n
Hardware Version: WR741N v1/v2 00000000
