Only one Antenna is working in TP Link MR600
Only one Antenna is working in TP Link MR600
I have checked there is only one antenna is working and receiving signal in TP Link MR600 router.Tested with both stock antenna and external antenna. Need suggestion from the community if someone else facing same issue.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Yes, for best results both antennas MUST be connected.
1 external antenna only & 1 internal antenna will work but usually in Non - MIMO mode, (if the signal to internal antenna is low) for MIMO mode to work you require 2 internal antennas (if the signal is high) & for a best results, 2 external antennas are required, it all depends on your signal strength received, i.e how far you are from the cell tower/s.
A higher signal strength on both streams (4G+ MIMO) means higher speeds (Mbps).
Read this for more information .... https://community.tp-link.com/en/home/forum/topic/272342
John vk3hjq
- Copy Link
- Report Inappropriate Content
I thought you said it was only working on 1 antenna, & that was your problem in the 1st place.
Now for this Question .....For this to happen (& it can) the signal strength must be very high, i.e you are very close to the cell tower.
It is not a good idea to run it with only 1 antenna connected as it is designed to run with 2.
John vk3hjq
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3618
Replies: 12
Voters 0
No one has voted for it yet.