@amolkalhapure I believe in the 'Advanced' tab you should also see RSRP, RSRQ & SNR values, which are all related to your signal strength.  Use the following chart to help:

                                              RSRP(dBM)       RSRQ(dB)     SNR(dB)    

(RF Conditions)  Excellent       >=-80                  >=-10            >=20

(RF Conditions)  Good            -80 to -90          -10 to -15      13 to 20

(RF Conditions)  Mid Cell       -90 to -100         -15 to -20       0 to 13

(RF Conditions)  Cell Edge      <=-100                <=-20            <=0

I currently get the following:    -97dBM               -8dB             18.2dB

CheerZ

@Fl1nst0ne Hello, Thanks for reply but it seems my admin panel don't have that ? :( 

Can you throw some more light on this ?

@amolkalhapure I only have the MR600 router but use to have the MR200 router and both have these values listed under the 'Advanced' tab.  I made a presumption that the MR400 router also llisted these values.  Have you upgraded to the latest firmware?

CheerZ

@Fl1nst0ne Hello, Just returned MR400 & ordered MR600 :)

@amolkalhapure Hi I have mr200 V2 as well. I don't see any dBi values like RSRQ, RSRP, SINR in my admin page too. After you buy MR600 could you access these dBi values? Is there any chance to access values without changing the product. Because I am happy with mr200 normally accept the dBi values.

By the way could you have chance to try your LPDA antennas. How much dBi could you gain with it. Could you share please. Thanks