Range Extenders
The Range Extender products are mainly designed to extend the coverage of your existing wireless network. For some models they even can be used as Access Point devices. In this section you can say hello to other members, ask, answer or discuss technical topics regarding Range Extenders.
Range Extenders
Lead In After connecting the range extender to the Host router, sometimes you might run into the following issues: There are several new clients under the client list. It seems like your own devices a
By
Jenny_M
Jenny_M1Helpful
1051Views
I have a 500 mbps router and when i use the extender om 2.4 or 5ghz i am only getting 30-90 mbps and on ethernet i am getting 30-80 mbps. How can i fix this because this is very slow compared to the r
2.5 GbpsNetwork ConnectivityInstallationAccess Controlslow
By
Farooq5
0Helpful
18Views
Official ReleaseEasyMesh Range Extenders Start Supporting Building a EasyMesh Network via Ethernet Backhaul
This Article Applied to: RE315_V1 RE315_V1_1.0.30 Build 230919 RE900XD_V1 RE900XD_V1_Build_20240411 RE655BE_V1 Supported on the factory firmware. RE800BE_V1 Planned What is EasyMesh with Ethernet Back
Firmware UpdateEasyMeshEasyMesh Ethernet Backhaul
86Helpful
16747Views
0Helpful
28Views
Hello, I setup my extender yesterday and it's working brilliantly great speed. Last night I tried to connect my Chromecast to the new extended network. I get tot he very end of the setup and it says i
Access Point Mode
0Helpful
78Views
I have a VR2100 setup in router mode and 2x mesh nodes an RE305 and RE450 both nodes mesh up no issues with the VR2100 but here is the weird issue, both mesh nodes are setup with static addresses in t
0Helpful
113Views
Good afternoon. I acquired the RE330 in August. I need it to extend one network to be used with surveillance cameras. One of the cameras is slightly out of the range of the main router (Archer MR550)
Network Connectivity
By
miracle2012
· Latest post 19 hours ago
by Joseph-TP
0Helpful
43Views
I have a TP LINK RE200 Range Extender. it used to work fine but recently it's just stopped working. the LED light will keep on blinking, then all the lights turn green for half a second, then the Wi-F
By
Dhanabalan
0Helpful
21Views
I have a modem on the 2nd floor. I ran a cat 6 cable from the 2nd floor to the 4th floor, and fixed the device to the 4th floor. When I enter the cat6 cable into the device, the device does not work.
Network ConnectivityInstallation
0Helpful
39Views
When the range extender is connected the internet works fine from the extender, although limited to 15-20 Mbps of the 200 available on my main router. But when it's connected the router does not allow
Access Point Mode
0Helpful
37Views