Tapo Smart Plug
When connectin smart plug into the router network it works correctly. But I have 3 AP in my home and connecting to them smart plug just can't connect to the network. I tried direct connection to the r
Installation
By
duszekmestre
· Latest post Tuesday
by Wayne-TP
2Helpful
106Views
Hi everyone, I have multiple SSIDs set up in different parts of my network. Currently, I have a TP-Link Tapo account with two devices connected to one SSID. I recently purchased a P110 smart plug and
Installation
1Helpful
179Views
I have two P110 devices which were very intermittent when working which I put down to a low Wi-Fi signal. I have now moved them both into a very strong Wi-Fi environment [same room as router] and remo
Installation
0Helpful
177Views
Issue adding the plug to Apple Home. Getting "Unable to Pair" error. Have tried the steps in https://www.tapo.com/au/faq/199/ Resetting the plug by holding the button for 10s until the LED flashes gre
InstallationMatterHomeKit
3Helpful
578Views
If it won't pair, in wifi installation, have a look at what WPS is doing on your wifi router, probably has the same effect on all smart plug installations, good luck! Tim B
InstallationMatter
By
timbre1303
· Latest post 2024-07-11 07:23:14
by timbre1303
1Helpful
298Views
TroubleshootingWhy My Tapo/Kasa Devices Not responding in Apple Home App?
This Article Applies To Tapo/Kasa HomeKit and Matter models Background The Tapo/Kasa devices that support HomeKit or Matter can be configured and controlled directly through the Apple Home app. Remote
HomeKitMatterInstallation
By
Wayne-TP
Wayne-TP0Helpful
224Views
H/w & F/w versions not known, as I cannot get the plug connected to the Tapo app on my iPhone. I already have two P100 plugs that connected OK. I tried all the various options suggested but nothing wo
Installation
0Helpful
710Views
Disconnected p100m smart plug from app as only working on home wi fi. now trying to reconnect and it can't find wi fi. I have reset to factory settings etc
Installation
0Helpful
232Views
Hi im trying to setup 2 of mine P110 at a new site. So I try to reset them to be able to set them up. But They start to blink green/orange but there is no WiFi to connect to. So, how can I make them s
Installation
0Helpful
388Views
Hello im using the following network gateway Eero 6+ mesh network i have used legacy mode and restricted to 2.4GH as well i cannot find the device wifi i also have HS100 connecting fine however using
Installation
0Helpful
224Views