Razvan974LV2Online
Following: 0Followers: 0
Forums/ Wi-Fi Routers
By Tihomir 2021-02-12 21:05:37

Archer AX73 reboot when connect LAN NAS to it

Hi, I get new my new AX5400 Wi-Fi 6 Router 2 days ago. After the initial setup, I connect my QNAP 231P NAS via LAN to it and the router starts randomly reboot. 2 days I try to find the problem why the
Forums/ Wi-Fi Routers
By VA3TWT 2020-06-11 20:18:27

AX 50 Heat Issue

Good day; I just purchased my Archer AX 50 router yesterday and have been using it most of the day. It is sitting on my desk and I was going to move it to a new location in my office and noticed that
Forums/ Wi-Fi Routers
By steve79 2020-04-18 18:08:52

AX50 USB3 transfer very slow

Hi, AX50 claims to have USB3.0 enabled port but my transfer speed is very slow. 20-30 MB/S through wired 1gbps ethernet and 1.5gbps wifi. So basically USB2 speeds. Tried several usb3 hdds and usb3 ssd
Forums/ Wi-Fi Routers
By konkandesi 2019-03-14 22:23:05

TP-LINK Archer C9 LED's are quite dim

The router used to definitely have a lot brighter LED's, now they seem quite faint, even in a dark room. Is there a way to adjust the LED brightness?
Forums/ Wi-Fi Routers
By Razvan974 2019-06-20 08:53:09

Archer C9 - status page didnt refresh. CPU and memory load, refreshed only after change the menus

Hello, After upgrade from Archer C7 V4 which had some PPPoE - NAT problems, this working wery well except the status page where cpu load and memory usage do not show in real time like C7 does. It refr
Forums/ Wi-Fi Routers
By Razvan974 2019-05-18 09:32:40

Archer C7 V4 and V5 NAT problem on PPPoE connections ( again)

Hello, Again about this problem reported on old forums, on this forums and with TP-Link support from Romania. It is about C7 model, not A7. You even did not have this model with any firmware in the li