Hi, I've been tearing my hairs out with trying to get this ER605 working on my ISP's IPv6. The IPv6 worked just fine on my former TP-Link AX55 WiFi router, but never on the ER605. I tried it with and

I have a public IP block (/26) assigned to me by my ISP (AT&T). The modem is setup to forward all traffic to this block to the cascaded router (ER605). However, I can't figure out how to setup the ER6

CPU is never below 13-17%, is this normal or is it another bug on this device?

Hey Folks, I've got an ER7206 setup through Omada Controller V5.5.6. Internet coming in via SFP WAN. I am unable to configure IPTV in my current configuration as on the selection screen under WAN Port

Hi Everyone, Note : Standalone Mode (Omada Controller not available). My Question ---> How to reduce time of Switching WAN to WAN2 on Disconnection for Internet access. eg. When WAN1 gets disconnected

Hello, When I create a new Vlan: Wired Network -> Lan -> Create a new Lan, and use Manual default gateway, this is not taking any effect, the dhcp always give me the default gateway as gateway, i.e 10