MarkoJLV1Online
Following: 0Followers: 0
Forums/ Deco
2020-08-20 13:45:03
Re:Deco M9 Plus Overheating Cutting performance
@CJE i returned my devices.. When you put them on some spikes.. You can lower temp to around 50C. Could not figure any other method.. Unless you unbox it 😁.. Probably Not... Very good product...
0HELPFULS
Forums/ Deco
2020-08-12 09:22:10
Re:Deco M9 Plus Overheating Cutting performance
Actually heating oen was the secondary device.
0HELPFULS
Forums/ Deco
2020-08-12 08:50:05
Re:Deco M9 Plus Overheating Cutting performance
@WarrenTDO Thank you for your reply on status.. i measured 53 C underneath when i have it on 1 cm spikes.. so there is some room under.. i have yet to test the temp when it is flat on the surface......
0HELPFULS
Forums/ Deco
2020-07-24 07:44:03
Re:Deco M9 Plus Overheating Cutting performance
@cacb ..just a guess... the one that heats up is the main deco ? .. atleast thats my case.
0HELPFULS
Forums/ Deco
2020-07-24 06:26:01
Re:Deco M9 Plus Overheating Cutting performance
@SrDarkWarrior . i have the same issue with 1 of these two devices. It is running a real hot. i had it over a speaker and.. wonder my surprice... now i noticed that it had "burnt" the paint of the...
1HELPFULS
Forums/ Deco
2020-04-21 11:58:02
Re:Re:How to set up Deco to work in Access Point mode?
@TP-Link Deco Dont seem to work as expected ? .. I have setup where i have two decos M9 connected to root router LAN ports and also they create a new WLAN.. Situation now is that only primary Deco...
0HELPFULS