Forums/
Deco
2019-10-30 11:01:07
@kostaK I have 6 P7's and 2 of them are connected with Ethernet to the same LAN as the Fritzbox. The rest of the network the P7's will figure out themselves, no need to connect them using Ethernet,...
0HELPFULS
Forums/
Deco
2019-10-30 10:54:08
@kostaK IMHO the AP mode is a simplified version of the AP mode as a good example in non-AP mode Internet addresses -> Fritzbox addresses -> Deco addresses in AP mode Internet addresses -> Fritzbox...
0HELPFULS
Forums/
Deco
2019-10-30 09:46:57
@kostaK - as you have a extremely capable router (The Fritzbox) I would personally run the Deco's in AP mode - it makes everything simpler IMHO. It's the way I run my Decos and Fritzbox. Tor
0HELPFULS
Forums/
Deco
2019-10-26 08:26:19
@bds_ It's dynamic - it will have to be in a mesh network. In my case changing the RSSI values made all the difference in connecting to the stringes signal, not anything else. Tor
0HELPFULS
Forums/
Deco
2019-10-25 08:40:33
@bds_ And the information is readily available in the OS - from one of my nodes (sorry about the bad formatting) wlanconfig ath13 list ADDR AID CHAN TXRATE RXRATE RSSI MINRSSI MAXRSSI IDLE TXSEQ...
0HELPFULS
Forums/
Deco
2019-10-25 07:27:27
@Razr I never raised a support ticket - the only contact I have had with them until the call was set up was through this forum. It may have been because I supplied opinions underpinned by facts? I...
0HELPFULS