@Christiaan1981 As I know, R600VPN only support to be a VPN server if choose Client-to-LAN IPSEC. And its IPsec VPN doesn't support to route all traffic over the VPN. Maybe it cannot meet your...

@JulioSilva You just need to change the PVID to 70 for the port 2, and set the egress rule as untagged for port2 on VLAN2.

@AshleyNL I think your T2600G only has one L3 interface for VLAN1 and its IP address is 192.168.0.3. Please make sure use the client belong to VLAN1 when access T2600G. You mentioned that the Router...

@JLTHLA What's the hardware version of your R600VPN? As I know, you don't need to connect your client to the particual port for DMZ. Because R600VPN hasn't physical DMZ port. And DMZ should work as...

@Christiaan1981 A little confused. StrongSwan is your VPN server or R600VPN is your VPN server? And where did you set the routes 0.0.0.0/0? If you set the route on your PC, it may make your PC send...

@Jojo42 The NAT throughput should not limit your speed. But I think it's hard to require the full speed of both WAN. The traffic will go to two WAN randomly. You can try to set up bandwidth in WAN...