K3dareLV1Online
Following: 0Followers: 0
Forums/ Requests & Suggestions
2024-10-19 11:23:47
IPv6 Routes and support in general
Hello. Today, the IPv6 support is missing a lot of features : - There are no way to see the IPv6 routes (the Insights->Routing Table page on the controller only shows IPv4 ones) (high priority) -...
4HELPFULS
Forums/ Requests & Suggestions
2024-10-19 11:17:57
LAN to LAN ACL
Hello. Today, when setting up LAN to LAN ACL, it's not possible to do any configuration other than in/out interfaces, for example we cannot filter by IP or port. It would be interesting to be able to...
0HELPFULS
Forums/ Requests & Suggestions
2024-10-19 11:12:20
Re:[Improvement] Set SNMP sysName on Omada devices
Looks like it's coming soon for the EAP, I can see it on the RC release logs of " 1.1.0 Build 20240830 Rel. 50868 " for EAP653. > Supports configuring the Device Name in Controller mode, which can be...
0HELPFULS
Forums/ Requests & Suggestions
2024-09-08 11:43:23
[Improvement] Set SNMP sysName on Omada devices
Hello :) A small feature request that would be interesting and probably very easy to implements on Omada devices. Right now, appart on the switches, the SNMP device name set on the controller doesn't...
4HELPFULS
Forums/ Routers
2024-08-15 10:57:29
Re:[IPv6] Cannot open firewall from WAN to LAN
I suspect I may have found the issue. It looks like the connection state (in devices > the gateway > WAN port) is not really consistent. It was in a disconnected state but I had working IPv6...
0HELPFULS
Forums/ Routers
2024-08-15 10:07:25
Re:[IPv6] Cannot open firewall from WAN to LAN
@Clive_A Hello, thank you for your fast message. I cannot ping the WAN IPv4 of the gateway, even from the network device right in front of it (ESBCN-HEX1, that provide the RA on the WAN side and that...
0HELPFULS
12