What i mean is, my firewall appliance does not care about traffic between devices on my LAN. It only has a policy to perform it's duty on traffic in to my network, i.e. unauthorized exterior access....

R1D2 wrote There you have it (you probably meant LAN to WAN?). Either allow traffic from LAN to LAN or open at least the following ports for the system running the EAP controller: UDP port 29810, TCP...

R1D2 wrote Try the TP-Link Discovery Tool to configure the EAPs: If this works, your Windows system did prevent automatic discovery of the EAPs for some reason. That's normal, Windows always makes...

Thanks, but still no luck. I just reset all three to factory settings, and despite giving each access point a Static IP of 10.0.1.3, 10.0.1.4, and 10.0.1.5, my computer running the Controller, on...

AHA! Thank you. That makes more sense. I thought out of the box the APs would be seen immediately by the controller software! Thank you very much.

Model : Hardware Version : Firmware Version : ISP : I purchased 3 EAP245 access points and have them connected to a TP Link Unmanaged POE+ 8 port switch. The switch is connected to my core network...