Migz wrote Hi Nolan, is it possible to convert the new 2.23 firmware for the v2 adapters to use on the v1? Cheers Sure. Right here >> 2.2.3 for the TP-PL8030P V1 Notice: this is a straightforward...

Yea, mine top max @ 25 MB/s.. If you plan to go back on the 2.0.0-05 firmware, use the same method you did to upgrade to this 2.2.2-00.

Try to set MODE to "Normal Mode" instead of "Lower PLC-to-VDSL" on both ( if the option is already set, change it, save and re-apply ) it's a new option available only on the lastest TP utility...

It should be a straightforward flash on PORT 1. I'd advise to NOT enter the bootloader mode unless necessary, know that flashing the firmware from it will rewrite all the parameter and require to...

Mine PLC are the P ( passthrough ) version too. To be specific 8030P v1 AV1200. The 5 MB/s ( 40 Mbit ) are on real data transfers on internal LAN over the power socket, not from the utility bandwidth...

The vaule within this firmware are stock. Anyhow, mine are the passthrough (P version) too. The photo is just to show the right port.