For ref.: https://community.tp-link.com/en/business/forum/topic/541960?replyId=1072486

This is a quick follow up from the previous thread. So, in short. NO, it did not work. But I found something. Forget about Load Balancing, just disable that, BUT do configure the detection on each...

One thing I found out: The router takes the DNS from WAN1 if you are using policy routing. So, beware of ood behaviour from OpenDNS on this device. All devices routed to WAN2 on Priority or Only...

@Virgo After reading the following on the KB: https://www.tp-link.com/us/support/faq/701/ - This Article Applies to: TL-R470T+( V6 ) , TL-R480T+( V9 ) , TL-ER5120( V3 ) , TL-R600VPN( V4 ) ,...

@Virgo thanks for the guidance. But still, the router is not routing properly. I tried making manual routes and setting proper metrics but it gives an error, so I cannot "override" the default routes...

My setup is as follows: Two WAN links (possibly one more in the future): WAN1: 100mbps WAN2: 2mbps (for OOB and emergency access for 3 computers that need always access for administrative stuff,...