i tried updating my three EAP610 v2 to the 1.1.2 builds last week and one of my access points was no longer accepting connections. devices were unable to connect to it so i rolled back to 1.0.2 on...

@Hank21 i updated my EAP610's to this firmware and two of them refused to allow clients to connect. was this a known issue? i had to revert my firmware back.

@DaKings is your switch connected by ethernet cable back to your main router or are they going to be using wifi backhaul? powerwise, as stated, should would i would think

@neillybeg the wall EAP's are only powered by PoE i believe so a PoE switch would ne necessary to power it.

@Seaquest47 have you tried reflashing the firmware? its possible that its defective.

@neillybeg its easier to have active internet (through ethernet) while the setup process is working. you will need a router to connect to at least the first access point by wire to set up the rest....