Please provide a proper CPE Connection Log. e.g. A Wallbox EV Charger Station had a serious WiFi bug ( it would deauth itself, and not re-connect ) It was impossible to troubleshoot this, as the...

One of my Stations is a Wallbox Pulsar Plus EV Charger, that had a serious bug ( e.g. it would deauth itself, and not re-connect ) I was not able to troubleshoot this, as the CPE210 Log has no...

Very basic Network Question CPE210 Access Point with one Station: Why is Total traffic on each Interface exponentially different ? e.g. Bridge TX Bytes: 8M, LAN0 TX Bytes: 92M, WLAN0 TX Bytes: 405M...

@cristianvdr ( Cont'd ) In "AP Router" Mode, there are "Access Control" settings, that allow for Host, Target, Day of Week, and Hours. However, I was unable to make any sense of it Instead, I set the...

@cristianvdr [ EDITED ] 1. Your "Save" Changes Button is ingenious I set the Unit back to "Access Point", clicked "Apply" ( but not "Save" ), then upgraded the Firmware with a wired connection Much...

@cristianvdr Yes, I did try a wired connection. Please note that the instructions warn that once in AP Router Mode, LAN becomes WAN, so no longer available for Management I suspect I may have to go...