@terziyski So, your description of Manual AP is just reverting to router mode and switching off DHCP (which I think is what I'd suggested in my initial message - my option 2)...? Obviously, if I'm...

@terziyski Thanks but I'm asking for a setup where I don't have to use them as non-EasyMesh "Manual" APs, as I already have them set up (and working) like that. I'm trying to find a way to put them...

I have an ER605v2 (load balancing between two ISPs, both their in Modem-only mode) and a few (hard-wired) C80s behind it; what is the best way of making use of EasyMesh on the C80s? Do I; Turn off...

@David-TP The RE800BE is far from a comparable device - for the size of it, and the cost, you might as well be using a full-on Router (e.g. a C80) as an EasyMesh satellite! Range Extenders with...

@Clive_A You assume right. None of the APs are Omada, as the ER605v2 has been the last to arrive. However, all the APs are all TP-Link devices (five C80s and an RE550), which are all Ethernet...

@Thomas_ER605 I'm hitting much the same issue. The DHCP client list on my ER605v2 (with the latest firmware) doesn't show all devices that are connected. The ER shows 61 in the client list, with 6...