Deco Network Deployment
Configuration GuideHow to set up Ethernet Backhaul with your Deco devices
Ethernet Backhaul is a feature that makes it possible to wire the Deco units together to optimize the bandwidth and network stability. Normally, after wired Deco units with an Ethernet cable, the Ethe
Highlighted ThreadDeco Ethernet BackhaulOfficial
19Helpful
466937Views
Upon viewing the product pages, there is a list of models. How to figure out which one best fits my needs? Pre-installed with Ethernet sockets in each room Almost All Deco models (Deco M3W is an excep
Deco Ethernet BackhaulConnection PreferencePowerline Backhaul
0Helpful
524Views
Knowledge BaseDeco Network Deployment
Lead-In Ready to invest Deco but still find it challenging to determine the most suitable mode? You're in luck! This article is here to assist you by listing the crucial factors that will guide you to
Access Point ModeDeco Ethernet BackhaulConnection PreferencePowerline Backhaul
1Helpful
794Views
Configuration GuideConnection Preference: Customize Your Preferred Signal Source
To create a comprehensive Home Wi-Fi system offering both excellent network speed and comprehensive wireless coverage, it is common to install more than two Deco Mesh units throughout the house. A rec
Highlighted ThreadOfficialConnection Preference
0Helpful
12992Views
My Deco PX50 units have been solid for months, but since last week they started crashing once or twice a day. They just stop working, wifi SSID sometimes disappears. Before they were setting wifi+PLC
Powerline BackhaulNetwork ConnectivityAccess Point Mode
By
ricardonadao
· Latest post 15 hours ago
1Helpful
19Views
This Article Applied to Deco S7_V1/V1.2 Current Release Deco S7_V1/V1.2 1.5.0 Build 20240329 ***The 1.7.0 Platform Understand the Differences Among Deco Firmware Platforms Firmware Modifications 1. Su
Firmware UpdateIoT NetworkConnection PreferenceDDNS
4Helpful
10512Views
Firmware Version:0.3.0 3.0.0 v6095.0 Build 240124 Rel.65899n Hardware Version:HB810 v1.0 00000000 Set Up = ISP(ONR) -> HB810(Router Mode) -> All devices Hi All, Before moving to tp-link HB810(BE22000)
Network ConnectivityWi-Fi 7Connection Preference
0Helpful
387Views
So I just upgraded from the older XE75 mesh router system to the new BE63. In trying to keep all my old settings i plugged in the new unit add chose to add to my then current setup. After adding to th
Network ConnectivityDeco Ethernet BackhaulGuest Network
By
TheBum0726
· Latest post Yesterday
by RavenInTexas
2Helpful
360Views
Hi. I am unable to edit the preferable band (2.4 or 5Ghz) to clients when the X50 devices are connected/syncd via cable. If I disconnect the cable, therefore they will communicate via WiFi and reducin
Firmware UpdateDeco App RelatedConnection Preference
0Helpful
45Views
I have 3 DECO P9, and was planning to extend coverage with 2 DECO PX50, they will still work under PLC network if I define the DECO PX-50 as Main Router? Thanks Pedro
Powerline Backhaul
By
PedroMP
· Latest post Yesterday
by Alexandre.
0Helpful
30Views