tpPLC not showing all adapters
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
tpPLC not showing all adapters
Model :
Hardware Version :
Firmware Version :
ISP :
I purchased two pairs of AV2000 (Version 1) TL-PA9020P. I downloaded the latest version of tpPLC and when run only shows three out of the four AV2000's connected?
The diagram shows two at the top and one below, which is connected to the other two. Why can I not see all four, all of which are working and all of which are successfully connected to the internet? One is connected to the router and the others to media players.
Hardware Version :
Firmware Version :
ISP :
I purchased two pairs of AV2000 (Version 1) TL-PA9020P. I downloaded the latest version of tpPLC and when run only shows three out of the four AV2000's connected?
The diagram shows two at the top and one below, which is connected to the other two. Why can I not see all four, all of which are working and all of which are successfully connected to the internet? One is connected to the router and the others to media players.