TP-Link 940N can't config
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link 940N can't config
Region : Argentina
Model : TL-WR1043ND
Hardware Version : V2
Firmware Version :
ISP :
Currently the company is using the 2 Router 940N. I use to connect fiber-optic and wireless (RT), only to detect (AP).
RT: 10.0.0.2/255.255.255.0
AP: 10.0.0.154/255.255.255.0
AP connected via LAN port to RT, DHCP is disabled. IP addresses on the LAN, WIFI is allocated from the RT.
However, lately the RT or faulty: Stay active but disconnected internet, no login to config is (Report Unable to connect), to turn off and then on again, the new RT-in time to connect to lose from 2-3p (formerly not so). Tried to update firmware but still did not get.
I have bought Archer D7, FTTH configuration delicious, but when plugged in, it can not connect it. Configuring TP-Link sends it sure is OK. Roads are still using normal cable.
Model : TL-WR1043ND
Hardware Version : V2
Firmware Version :
ISP :
Currently the company is using the 2 Router 940N. I use to connect fiber-optic and wireless (RT), only to detect (AP).
RT: 10.0.0.2/255.255.255.0
AP: 10.0.0.154/255.255.255.0
AP connected via LAN port to RT, DHCP is disabled. IP addresses on the LAN, WIFI is allocated from the RT.
However, lately the RT or faulty: Stay active but disconnected internet, no login to config is (Report Unable to connect), to turn off and then on again, the new RT-in time to connect to lose from 2-3p (formerly not so). Tried to update firmware but still did not get.
I have bought Archer D7, FTTH configuration delicious, but when plugged in, it can not connect it. Configuring TP-Link sends it sure is OK. Roads are still using normal cable.
