I have an Archer VR1600v from TPG which is playing up with the time shown. Hardware version: 2.0. Firmware version: 0.1.0 0.9.1 v5006.0 Build 220518 Rel.32480n

Issue: On the Time Settings page, Time Zone: GMT+10 time for Melbourne But the router kept giving the time one hour ahead of actual time.

Steps taken:

1. The NTP Sever I was: time dot nist dot gov, which is based in USA.

2, So I replace it with the Aussie one, still one hour ahead was shown.

3. Then I replaced with 0.0.0.0 in NTP Server I – same as that shown NTP Server II to avoid getting time from the internet. Then set time manually by choosing the option "Get from PC". Correct time shown for about 10-15 minutes and then it’s again 1 hour ahead.

Question: What could have caused that? Firmware? (Note: Firmware update controlled by TPG)